|
|
| |
| Ethernet based 30 channel Analog I/O - Sample 30 channels of 10 bit ADC plus 30 channels of 10 bit DAC. |
|
Proportional Servo Hydraulic Control Valve (Patented US9316237, US9441645) - Precision position control of linear hydraulic cylinders and rotary hydraulic actuators and velocity control of hydraulic motors is performed by this innovative valve assembly.
|
|
|
Video Signal Conversion - Convert from HDMI / DVI to LVDS or DUAL LVDS |
|
|
|
Spindle
Auto-Balancer - Dynamically change spindle balance to
compensate for unbalanced loads while the spindle is spinning up to speed.
Intelligent Machinery has the automated solution for your application. |
|
|
| Power Amplifier circuit assembly that provides up to
20 Amps peak output at +/- 35 Volts. Pure sinusoidal linear three phase
power to drive air-bearing or ball bearing spindles with extremely low
electrical noise. |
|
|
| |
| Air Bearing X-Y stage with Nano-positioning and
vacuum lockdown for ultra stability. This
positioning table can be configured for various X-Y positioning
applications. Please call us with your application and we will be glad to
review it with you. |
|
|
| |
| Precision
Motion Controllers
- Velocity control better than .0001% of the target RPM is achievable
with the Intelligent Machinery motion controller. Index to position and hold without the typical servo
dither in air-bearing systems. Ethernet, RS232 and GPIB
IEE488.2 communication interface built in. User definable digital on board I/O to
control application specific hardware. |
|
| |
| Torque Amplifier - Delivers three phase power to
brushless DC motors that are hall effect commutated. With linear six-step
power modulated by an external +/- 10V command voltage. Capable of 10 Amp
output with a +/- 35 volt DC power supply. The linear output eliminates
the electrical noise generated by standard PWM type motor drivers. TTL
Enable input, Thermistor over temp. protected. Ideal for very low noise
applications. |
|
|
| |
| Spindle Controller - Velocity control better than .0001% of the target RPM is achievable
with the Intelligent Machinery motion controller. Index to position and hold without the typical servo
dither in air-bearing systems. Ethernet, RS232 and GPIB
IEE488.2 communication interface built in. User definable digital on board I/O to
control application specific hardware. The integrated power amplifier circuit assembly provides up to
20 Amps peak output at +/- 35 Volts. Pure sinusoidal linear three phase
power to drive air-bearing or ball bearing spindles with extremely low
electrical noise. Additional user definable I/O for auxilary functions. |
|
|
| |
| Air Bearing Spindle- 40K RPM Maximum Speed, 8 Pole Brushless DC Motor, Kubler Laser Encoder, Provisions for pnuematic clamp, extremely low polar inertia for high accel/decel capabilty, <0.3uIN Axial and Radial Asynchronous motion error. Please call us with your application and we will be glad to
review it with you. |
|
| |
|
From Concept to
Completion
We provide innovative technical solutions
to meet your
custom requirements
For Information
Please Call
Intelligent Machinery
Inc.
Chico, CA 95973
PH: 530-588-9010
Copyright ©
1999-2022 Intelligent Machinery All
Rights Reserved.
Designated trademarks and brands are the property of
their respective owners.
|
